Wide Range Of Hawke Scope Rings Now At Pyramyd Air
Pyramyd Air is now stocking a wide range of Hawke scope rings. These include some interesting “special application rings” that could help you out of a tight squeeze when mounting a riflescope on your airgun.
One of them is the Extra High version of the Hawke Tactical Match rings. These rings are manufactured from high grade Aluminum and feature no less than 6 – yes six – Torx screws for the top cap.
However the real benefit of these chunky rings is their extremely high “saddle height”.
As shown in the diagram above, the saddle height for these Extra High rings is no less than 0.9 Inches (23mm). This could be extremely useful for situations where you need a high eyeline for the scope – as with some bullpup PCPs.
It could also be vital if you have a scope with an extremely large objective lens – more than, say 50mm – and need extra clearance to avoid the scope from contacting the barrel or shroud.
These Extra High Hawke scope rings are available in Weaver/Picatinny versions, as well as for regular airgun dovetails.
In this case, conventional scope rings can only provide sufficient space to mount a very short scope – like a Bugbuster – as is shown below.
To mount a longer scope, Hawke two-piece offset mounts can be a life-saver! In this case, the offset ring would be used as the front ring. The result will be much more real estate to support a longer scope.
Hawke Offset Rings are available with offsets either 1-Inch or 2-Inches. There are also Medium and High versions available. This gives you a choice of options for mounting regular-length scopes onto short-breech airguns.
Another interesting choice in the Hawke scope rings range is the steel rings. These provide an alternative to conventional Aluminum rings where you might prefer a more stylish, thinner appearance.
Again they’re all available now from Pyramyd Air.